Key Selection Information
| Selection Parameter | Confirmed Information |
|---|---|
| Function | GNSS low-noise RF amplifier |
| Frequency range | 1164 MHz to 1615 MHz |
| Supply range | 1.1 V to 3.3 V |
| Operating modes | Standard, low-power and high-gain |
| Noise figure | 0.7 to 0.9 dB reference values by mode |
| Gain | 15.5 to 19 dB reference values by mode |
| Package | PG-TSNP-6 |
| Product status | Active and preferred |
Product Overview
The BGA525N6E6327XTSA1 is the tape-and-reel orderable for Infineon’s BGA525N6 GNSS low-noise amplifier. It covers the 1164–1615 MHz GNSS spectrum and provides selectable standard, low-power and high-gain operating modes through GPIO control.
Gain, noise figure and linearity are mode- and frequency-dependent. The device should therefore be selected using the GNSS band and intended bias mode rather than by treating the highest gain or lowest noise figure as simultaneous broadband values.
Technical Specifications
| Parameter | Confirmed Information |
|---|---|
| Frequency range | 1164 MHz to 1615 MHz |
| Supply voltage | 1.1 V to 3.3 V |
| Gain reference values | 19 dB, 17.9 dB, 15.5 dB by mode/band |
| Noise figure reference values | 0.7 dB, 0.8 dB, 0.9 dB by stated conditions |
| Supply current examples | 3.4 mA, 1.5 mA, 2.3 mA by mode |
| IIP3 examples | 1 dBm, -2.5 dBm, -5 dBm |
| Input P1dB examples | -5 dBm, -2.5 dBm, -14 dBm |
| HBM ESD | 2 kV |
| Moisture sensitivity | MSL 1 |
| Package | PG-TSNP-6 |
Design Considerations
Use Infineon’s recommended input/output matching and grounding geometry for the exact package. Parasitic inductance around the ground connections can change both gain and noise figure in this frequency range.
GPIO mode control changes RF performance and current consumption. The selected system mode should be included in receiver sensitivity and blocker-linearity calculations rather than chosen solely for lowest current.
Quality & Verification Support
Third-party inspection or testing can be arranged according to customer requirements. Testing fees are borne by the buyer. Additional verification requirements can be discussed before shipment. After an order is placed, physical product, label, packaging, and Date Code photos may be provided where appropriate.
Request a Quote
To request a quotation, provide the manufacturer part number, required quantity, destination, target Date Code if applicable, and any testing or inspection requirements.
