Device Overview
74HC4052D,653 is a dual 4-channel analog multiplexer/demultiplexer in SOIC-16. Internally it provides two SP4T analog switch sections that share two select inputs and one enable input, allowing two signal paths to be routed in parallel from the same channel address.
Confirmed Technical and Ordering Data
| Parameter | Confirmed value | Scope / condition |
|---|---|---|
| Switch Configuration | Dual 4-channel multiplexer/demultiplexer | 2 x SP4T |
| Logic Controls | S0, S1 and E | E HIGH turns both switch sections off |
| HC Supply to Ground | 2.0 to 10.0 V | VCC-GND recommended range for 74HC4052 |
| Total Supply Span | 2.0 to 10.0 V | VCC-VEE recommended range |
| Switch Signal Range | VEE to VCC | switch voltage must stay inside the supply rails |
| Analog Input Headline | -5 to +5 V | possible with suitable split-supply arrangement; not a standalone supply rating |
| ON Resistance | 80 ohm typ @ 4.5 V; 70 ohm typ @ 6 V; 60 ohm typ @ 9 V | headline values referenced to VCC-VEE |
| Input Levels | CMOS | 74HC logic-control thresholds |
| Operating Temperature | -40 to +125 °C | Specified for the documented device/orderable |
| Exact Package | SO16, SOT109-1 | 16 leads; 3.9 mm body width |
Engineering Selection Guidance
The -5 V to +5 V analog range is achieved only when the supply rails support it; the switch signal itself must remain between VEE and VCC. It is therefore not a single-supply 10 V input-tolerance statement.
ON resistance changes with supply span: the headline 80/70/60 ohm typical values correspond to 4.5/6/9 V VCC-VEE conditions respectively.
Because both SP4T sections share S0, S1 and E, both channels select the same numbered branch at the same time; this is useful for paired analog paths but differs from two independently addressed multiplexers.
Lifecycle and Procurement
Nexperia currently lists the exact orderable 74HC4052D,653 as Active. The verified package is SOIC-16. Lifecycle information supports sourcing and design planning; it does not state HKEQGOO stock, lead time, MOQ or final availability.
Official Engineering Resources
Quality & Verification Support
Third-party inspection or testing can be arranged according to customer requirements. Testing fees are borne by the buyer. Additional verification requirements can be discussed before shipment.
Request a Quote
For 74HC4052D,653 sourcing, provide the required quantity, destination, target Date Code if applicable, and any inspection or testing requirements.
